Even though it is strong and durable but it still needs to be taken care of correctly because it can easily be broken or compromised. You can use dark-colored clays instead of light ones. If debris is getting stuck every time you DIY polymer clay accessories then you might want to consider hiding them instead of trying to remove them. Shake the brush and try to lightly fan out the brush bristles before use.Īny left-out materials in the sealer brush and come on to your current polymer clay jewelry project. To prevent the dust specks or debris from getting inside the sealer, make sure the brush you use to put the sealer on is free from any hairs, old sealer, or dust. Dust Or Hair Stuck In The Sealer?ĭealer may be wax, acrylic sealer, varnish, or liquid epoxy which is used as a finishing step on the polymer clay jewelry to give them a smooth finish. You’ll have to do this carefully as you may just end up revealing more specks by using this method. ![]() If you are worried that the adhesion won’t stick then you can sand the surface. You can cover the jewelry’s surface with inks, paints, chalks, acrylic paints, mica powders, or even metal trinkets. You can’t take the dirt or hair present inside the polymer clay jewelry but you can disguise it. What To Do If Hair Or Dirt Is Stuck In Polymer Clay Jewelry? You will only be able to get out the hair that is sticking out of the clay. This short takes the dirt off.īut if the hair was partially inside the clay then it is impossible to get the whole hair out. Lightly press it on the area and peel it off. Take out a piece of tape and lightly put it on the area where there is dirt and debris collected. If you’ve just made some polymer clay jewelry and got your fingerprints on them then you can use this method to smooth out the fingerprints as well. If cleaning is urgent and you haven’t got some rubbing alcohol on you then you can also use nail polish remover, making sure the remover is not colored.ĭip the Q-tip in rubbing alcohol and swipe across the clay surface. A friend of mine recommended Vaxxan’s 99% Isopropyl Alcohol to clean polymer clay jewelry. Use Acetone Or AlcoholĪs mentioned above another thing that you can do is to sip Q-tips into acetone and rub alcohol. And if it does get irregularly shaped then you can still smooth it out without that much trouble. If you just made your jewelry then you might just get away with it without damaging, avoiding embedding the pieces of lint or hair even further into the clay. The knife and tweezers are just about sharp enough that they can leave a mark on the jewelry. Note: Try to be careful while using those. If the dust pieces are large enough then you can try to simply grab the dust or pieces of hair with a knife or tweezers. If it’s just direct or hair then they both are easier to clean but if lint or dust is attached to your polymer clay jewelry then here’s how you will clean it, Use A Knife Or Tweezers If your polymer clay jewelry has already gotten dirty, you may have to do some little exercise and take some measures to clean them. ![]() Keep them in a separate compartment from other boxes.Do not wear them while swimming, sleeping, or showering.Keep the clay pieces away from high humidity so that the metal does not tarnish. ![]() Be careful not to drop them or place them in your purses or pockets.These are just some of the things which you need to look out for so that your polymer care jewelry does not wear out early. Do not keep it in a wet place for too long. Store with raw brass pieces with anti-tarnishing strips to slow oxidation. Clean with a damp cloth or Q-tip dipped in rubbing alcohol. Here are some simple do’s and don’ts to take care of your polymer clay jewelry, Do’s Don’ts Do put on as the last step in your beauty routine. Related Posts: How To Care For Polymer Clay Jewelry?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |